21.4.4      APPLY

SELFCAL APPLY [Type [Gain]]

Apply the self calibration solution. This is done only if the return status from the previous computation, SELF_STATUS, is greater than 0. SELFCAL APPLY automatically saves the parameters and results in the "selfcal-AMPLI.last" or "selfcal-PHASE.last" file, depending on the Type of solution applied.

Type is the type of solution to apply. The default is 'SELF_MODE', i.e. PHASE or AMPLI depending on the last type of self-calibration computed. Type can also take the DELAY value, where the "phase" corrections are interpreted as atmospheric path changes and scale as Frequency.

Gain is an optional gain factor (default is 1.) on the correction.