APPLY

            SELFCAL APPLY [Type [Gain]]

    Apply the self calibration solution. This is done only if the return  status
    from  the previous computation, SELF_STATUS, is greater than 0.  SELFCAL AP-
    PLY automatically saves the  parameters  and  results  in  the  "selfcal-AM-
    PLI.last"  or  "selfcal-PHASE.last"  file, depending on the Type of solution
    applied.

      Type is the type of solution to apply. The default  is  'SELF_MODE',  i.e.
    PHASE  or  AMPLI  depending  on  the last type of self-calibration computed.
    Type can also take the DELAY value, where the "phase" corrections are inter-
    preted as atmospheric path changes and scale as Frequency.

      Gain is an optional gain factor (default is 1.) on the correction.